Disclaimer: CurlingZone does not represent or endorse the accuracy or reliability of any Content posted on any Forums area and you acknowledge that any reliance upon such Content shall be at your sole risk. Any Content placed on any Forums area by users and anonymous posters are the views of the user posting the statement, and do not represent the views of CurlingZone or our partners, advertisers or sponsors. By posting anonymously, you are allowing your IP address to be displayed for identification purposes. CurlingZone reserves the right to remove any post at its discretion without warning or explanation.
Registered: Feb 2017
Location: Pilot butte
I am looking for advice on correcting a sheet of ice that is curling in hard from the outside wall and curling very little toward the wall.
This is one sheet of a three sheet curling rink. (The other two are curling a nice three - four feet in any direction)
I am trying to pebble up the low side gradually across the entire sheet and scrape level. Does anyone have recommendations on scraping patterns to correct this?